RPM Technology - PolyGone 305 Gel High Performance Polysulfide Depolymerizer, Stripping Agent | 2035-205

RPM Technology - PolyGone 305 Gel High Performance Polysulfide Depolymerizer, Stripping Agent | 2035-205

PolyGone 305 Gel is a high performance Industrial / Marine Grade polysulfide sealant depolymerizer / emulsifier designed to remove cured polysulfide and other sealants from a variety of surfaces. Polysulfide's primary industrial application is in window (fenestration) industry where is it used to create the long lasting seal between double and triple pane window units. In the marine environment, polysulfide is used to seal teak decks, fuel systems, and through-hulls. The Gel version is the consistency of grape jelly and allows for its use on vertical and inverted surfaces or for spot removal.

PolyGone 305 Gel is a proprietary formulation designed to penetrate, break down, and emulsify tenacious sealants. Once broken down, the sealant is suspended to prevent re-deposition and enable easy rinsing.

PolyGone 305 Gel is intended for use at room temperature (68°F-80°F). Heat (120°F/49°C) and/or gentle agitation, including ultrasonic, is not necessary but significantly enhances performance. The agitation removes the digested sealant and exposes underlying layers to fresh PolyGone 305 Gel. PolyGone 305 Gel must be used at full strength. Dilution and/or excessive heat, above 120°F will deteriorate the emulsifier. RPM Technology recommends using PolyGone 305 Gel in a well-ventilated area and in a covered cleaning apparatus to prevent product evaporation.

PolyGone 305 Gel is water-soluble. Although water may be used to rinse the product, rinsing with a mild cleaner such as eOx, also available from RPM Technology, followed by pure water will improve removal of all residues. An emulsifier will improve rinsing via a "sheeting" effect, reduce sealant re-deposition, and reduce water usage. In cases where water is not preferred, a compatible solvent such as IPA or acetone may be used.

PolyGone 305 Gel is metal-friendly. The formulation is non-ionic and non-reactive. Metals such as Cu, Fe, Al, Zn, and Ti have been tested with PolyGone 305 Gel with no detected metal loss. However, PolyGone 305 Gel attacks many types of polymers and plastics. Polyvinyl chloride (PVC), polyvinyl alcohol, and similar plastics should not be treated with PolyGone 305 Gel. Many elastomers are also not recommended. RPM Technology recommends the following plastics for application and storage, Polypropylene, Poly Olefin, Polyethylene (low and high density), Teflon, and Butyl Rubber. Testing is necessary to demonstrate full compatibility.